yitree.blogg.se - Hilti anchors homedepot

#HILTI ANCHORS HOMEDEPOT DRIVER#
#HILTI ANCHORS HOMEDEPOT MANUAL#

#HILTI ANCHORS HOMEDEPOT DRIVER#

using a torque wrench, driver drill or cordless 1/4" impact driver with a maximum permitted torque rating of 100 ft. Models THD37134H and THD37212H do not meet minimum embedment depth requirements for strength design and require maximum installation torque of 25 ft. Not for use in other corrosive or outdoor environments. Intended for some pressure-treated wood sill plate applications. Mechanical galvanizing meets ASTM B695, Class 65, Type 1. Larger holes are not required for wood or thinner cold-formed steel members. Suggested fixture hole sizes are for structural steel thicker than 12 gauge only. Tighten the anchor into the base material until the hex-washer head contacts the fixture.epoxy grout shall be hy150 cartridge system by hilti: (hilti re500, if hole is cored instead of drilled) or approved equal, uno.

#HILTI ANCHORS HOMEDEPOT MANUAL#

Insert the anchor through the fixture and into the hole. Maxi-Bolts, embraced Hilti HDA undercut anchors, and then also allowed the Hilti KB-TZ CAD Standards Manual STD-342-300 POC Scott Richardson Section Section/Title Rev.

(Overhead installations need not be blown clean.) Alternatively, drill the hole deep enough to accommodate embedment depth and the dust from drilling and tapping. Drill the hole to the specified embedment depth plus minimum hole depth overdrill (see table below) to allow the thread tapping dust to settle, and blow it clean using compressed air.

Drill a hole in the base material using a carbide drill bit the same diameter as the nominal diameter of the anchor to be installed.

Simpson Strong-Tie Research and Testing Laboratory at WSU.

Simpson Strong-Tie Materials Demonstration Laboratory at Cal Poly.

New Product Testing in a Virtual Environment.

Outdoor Living: Where Great Backyards Begin.

Soft-Story Retrofit for Building Owners.

Component Manufacturer Software Solutions.

Anchoring Solutions for Value-Added Manufacturing.

Cross-Laminated Timber (CLT) & Mass Timber Connector Products.

Unreinforced Masonry (URM) Building Retrofit.

FX-70® Structural Repair and Protection System